Yaskawa J1000 Compact Vector Control Drive - Manual (Page 202)

No. Name Description
L8-07
Output Phase Loss Protection
Selection
0: Disabled
1: Enabled (triggered by a single phase loss).
2: Enabled (triggered when two phases are lost).
L8-09
Output Ground Fault Detection
Selection
Refer to V1000 Technical Manual for details.
L8-10
Heatsink Cooling Fan Operation
Selection
0: Fan On-Run Mode
1: Fan always on
L8-11
Heatsink Cooling Fan Operation
Delay Time
Refer to V1000 Technical Manual for details.
L8-12 Ambient Temperature Setting Refer to V1000 Technical Manual for details.
L8-15
OL2 Characteristics Selection at
Low Speeds
Refer to V1000 Technical Manual for details.
L8-18 Soft Current Limit Selection Refer to V1000 Technical Manual for details.
L8-19
Frequency Reduction Rate during
OH Pre-Alarm
Refer to V1000 Technical Manual for details.
L8-29
Current Unbalance Detection
(LF2)
Refer to V1000 Technical Manual for details.
L8-35 Installation Method Selection Refer to V1000 Technical Manual for details.
L8-38 Carrier Frequency Reduction
0: Disabled
1: Enabled below 6 Hz
2: Enabled for the whole speed range
L8-40 Carrier Frequency Reduction Time Refer to V1000 Technical Manual for details.
L8-41 High Current Alarm Selection Refer to V1000 Technical Manual for details.
L8-51 STo Fault Detection Level
Refer to V1000 Technical Manual for details.
Note: Available in drive software versions PRG: 1018 and later.
L8-54 STo Deviation Detection
Refer to V1000 Technical Manual for details.
Note: Available in drive software versions PRG: 1018 and later.
n1: Hunting Prevention
Use n1 parameters to configure hunting prevention operation.
n1-01 Hunting Prevention Selection Refer to V1000 Technical Manual for details.
n1-02 Hunting Prevention Gain Setting Refer to V1000 Technical Manual for details.
n1-03
Hunting Prevention Time Constant Refer to V1000 Technical Manual for details.
n1-05
Hunting Prevention Gain while in
Reverse
Refer to V1000 Technical Manual for details.
n2: Speed Feedback Detection Control Function
Use n2 parameters to configure the Speed Feedback Detection Control function operation.
n2-01
Speed Feedback Detection Control
(AFR) Gain
Refer to V1000 Technical Manual for details.
n2-02
Speed Feedback Detection Control
(AFR) Time Constant
Refer to V1000 Technical Manual for details.
B.1 Parameter Table
202 YASKAWA ELECTRIC TOEP C710606 47C YASKAWA AC Drive – V1000 Quick Start Guide