Yaskawa J1000 Compact Vector Control Drive - Manual (Page 196)

No. Name Description
H3-14 Analog Input Terminal Enable
Selection
Determines which analog input terminal or terminals will be enabled
when a digital input programmed for “Analog input enable” (H1-
 = C) is activated.
1: Terminal A1 only
2: Terminal A2 only
7: All terminals enabled
Note: Available in drive software versions PRG: 1016 and later.
H3-16 Terminal A1 Offset
Enter a 0 V signal to terminal A1. Next adjust the offset in H3-16
until the monitor U1-13 for the terminal A1 input voltage reads 0.0%.
The process is the same for terminal A2.
Note: Available in drive software versions PRG: 1016 and later.
H3-17 Terminal A2 Offset
Enter a 0 V signal, and adjust the offset for terminal A2 in H3-17
until the monitor U1-14 for terminal A2 input voltage reads 0.0%.
Note: Available in drive software versions PRG: 1016 and later.
H3 Multi-Function Analog Input Settings
H3-
Setting
Function Maximum Input Level Possible
0 Frequency Bias Max output frequency (E1-04).
1 Frequency Gain Frequency reference (voltage)
2 Auxiliary Frequency Reference (used as multi-step speed 2) Max output frequency (E1-04)
4 Output Voltage Bias
200 V Class: 200 V
400 V Class: 400 V
7 Overtorque/Undertorque Detection Level
Open Loop Vector: Motor rated torque
V/f control: Drive rated current
B PID Feedback 10V = 100%
C PID Set Point 10V = 100%
E Motor Temperature (PTC input) 10 V = 100.00%
F Not used/Through Mode –
10 FWD Torque Limit Motor rated torque
11 REV Torque Limit Motor rated torque
12 Regenerative Torque Limit Motor rated torque
15 FWD/REV Torque Limit Motor rated torque
16 Differential PID Feedback 10 V = 100%
30/31 DriveWorksEZ Analog Input 1/2
These settings are for analog output
functions used in DriveWorksEZ.
Normally there is no need to change or
apply these settings.
41
Output Voltage Gain
Note: Function available in versions PRG: 1016 and later.
10 V = 100.00%
B.1 Parameter Table
196 YASKAWA ELECTRIC TOEP C710606 47C YASKAWA AC Drive – V1000 Quick Start Guide