Yaskawa J1000 Compact Vector Control Drive - Manual (Page 192)

H1 Multi-Function Digital Input Selections
H1-
Setting
Function Description
41
Reverse Run Command (2-wire
sequence)
Open: Stop
Closed: Reverse run
42
Run Command (2-wire
sequence 2)
Open: Stop
Closed: Run
43
FWD/REV Command (2-wire
sequence 2)
Open: Forward
Closed: Reverse
44 Offset Frequency 1 Addition Closed: Adds d7-01 to the frequency reference.
45 Offset Frequency 2 Addition Closed: Adds d7-02 to the frequency reference.
46 Offset Frequency 3 Addition Closed: Adds d7-03 to the frequency reference.
47 Node Setup
Closed: Node Setup for SI-S3/V enabled.
Note: Available in drive software versions PRG: 1016 and later.
60
DC Injection Braking
Command
Closed: Triggers DC Injection Braking (b2-02)
61 External Search Command 1
Closed: Activates Current Detection Speed Search from the max. output
frequency (E1-04) if b3-01 = 0.
62 External Search Command 2
Closed: Activates Current Detection Speed Search from the frequency
reference if b3-01 = 0. Activates Speed Estimation Type Speed search if
b3-01 = 0.
65 KEB Ride-Thru 1 (N.C.)
Open: KEB Ride-Thru 1 enabled
Closed: Normal operation
66 KEB Ride-Thru 1 (N.O.)
Open: Normal operation
Closed: KEB Ride-Thru 1 enabled
67 Communications Test Mode Tests the MEMOBUS/Modbus RS-485/422 interface.
68 High-Slip Braking Closed: High-Slip braking is executed. Drive stops.
6A Drive Enable
Open: Drive disabled. If this input is opened during run, then the drive will
stop as specified by parameter b1-03.
Closed: Ready for operation.
75 Up 2 Command
Open: Maintains the current frequency reference
Closed: Increases or decreases the frequency reference.
76 Down 2 Command
7A KEB Ride-Thru 2 (N.C.)
Open: KEB Ride-Thru 2 enabled
Closed: Normal operation
7B KEB Ride-Thru 2 (N.O.)
Open: Normal operation
Closed: KEB Ride-Thru 2 enabled
7C Short-Circuit Braking (N.O.)
Open: Normal operation
Closed: Short-Circuit Braking
7D Short-Circuit Braking (N.C.)
7E Forward/Reverse Detection Direction of rotation detection (for Simple V/f w/PG)
90 to 96 DriveWorksEZ Digital Input 1
to 7
These settings are for digital input functions used in DriveWorksEZ.
Normally there is no need to change or apply these settings.
B.1 Parameter Table
192 YASKAWA ELECTRIC TOEP C710606 47C YASKAWA AC Drive – V1000 Quick Start Guide