HEIDENHAIN TNC 620 (81760x-02) - Manual (Page 62)

First steps with the TNC 620
1.4 Graphically testing the first part (Advanced Graphic Features
software option)
1
62
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 2/2015
Starting the test run
Press the RESET + START soft key: The TNC
simulates the active program up to a programmed
break or to the program end
While the simulation is running, you can use the
soft keys to change views
Press the
STOP soft key: The TNC interrupts the
test run
Press the START soft key: The TNC resumes the
test run after a break
Further information on this topic
Running a test run: see "Test run", page 548
Graphic functions: see "Graphics (option 20)", page 536
Adjust the simulation speed: see "Speed of the setting test
runs", page 537