HEIDENHAIN TNC 620 (81760x-02) - Manual (Page 578)

MOD functions
17.10 Setting up data interfaces
17
578
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 2/2015
Define behavior after reception of ETX
(noEotAfterEtx)
With define behavior after reception of ETX (optional) you
determine whether the EOT character is sent after the ETX
character was received.
TRUE: The EOT character is not sent
FALSE: The EOT character is sent
Settings for data transfer with the TNCserver PC
software
Enter the following settings in the user parameters
(
serialInterfaceRS232 / definition of data blocks for the serial
ports / RS232 ):
Parameters Selection
Data transfer rate in baud Has to match the setting in
TNCserver
Data transmission protocol BLOCKWISE
Data bits in each transferred
character
7 bits
Type of parity checking EVEN
Number of stop bits 1 stop bit
Specify type of handshake: RTS_CTS
File system for file operations FE1