HEIDENHAIN TNC 620 (81760x-02) - Manual (Page 545)

Graphics (option 20) 16.1
16
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 2/2015 545
Measurement of machining time
Machining time in the Test Run mode of operation
The control calculates the duration of the tool movements and
displays this as machining time in the test run. The control takes
feed movements and dwell times into account.
The time calculated by the control can only conditionally be used
for calculating the production time because the control does not
account for machine-dependent times, such as tool change.
Machining time in the machine operating modes
Time display from program start to program end. The timer stops
whenever machining is interrupted.
Activating the stopwatch function
Shift the soft-key row until the soft-key for the
stopwatch functions appears
Select the stopwatch functions
Select the desired function via soft key, e.g. saving
the displayed time
Soft key Stopwatch functions
Store displayed time
Display the sum of stored time
and displayed time
Clear displayed time