HEIDENHAIN TNC 620 (81760x-02) User Manual
Page 39
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 2/2015
39
12.5 FUNCTION TCPM (option 9).............................................................................................................. 445
Function................................................................................................................................................. 445
Defining the TCPM FUNCTION............................................................................................................ 445
Mode of action of the programmed feed rate..................................................................................... 446
Interpretation of the programmed rotary axis coordinates...................................................................446
Type of interpolation between the starting and end position............................................................... 448
Resetting the TCPM FUNCTION.......................................................................................................... 449
12.6 Three-dimensional tool compensation (option 9)........................................................................... 450
Introduction........................................................................................................................................... 450
Definition of a normalized vector..........................................................................................................451
Permissible tool shapes........................................................................................................................ 452
Using other tools: Delta values............................................................................................................ 452
3-D compensation without TCPM........................................................................................................ 452
Face milling: 3D compensation with TCPM......................................................................................... 453
Peripheral milling: 3-D radius compensation with TCPM and radius compensation (RL/RR)................ 454