Tnc model, software and features – HEIDENHAIN TNC 620 (81760x-02) User Manual
Page 17
TNC model, software and features
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 2/2015
17
Modified functions 81760x-02
FZ and FU feed rate input possible in the Tool Call block ("Call tool
data", page 182).
The input range of the DOC column in the pocket table has
been expanded to 32 characters ("Pocket table for tool changer",
page 179).
Commands FN 15, FN 31, FN 32, FT and FMAXT from predecessor
controls no longer generate ERROR blocks during import. When
simulating or running an NC program with these commands, the
control interrupts the NC program with an error message that helps
you to find an alternative implementation.
Miscellaneous functions M104, M105, M112, M114, M124, M134,
M142, M150, M200 - M204 from predecessor controls no longer
generate ERROR blocks during import. When simulating or running
an NC program with these miscellaneous functions, the control
interrupts the NC program with an error message that helps you
to find an alternative implementation ("Comparison: Miscellaneous
functions", page 635).
The maximum file size of files output with FN 16: F-PRINT has been
increased from 4 kB to 20 kB.
The Preset.PR preset table is write-protected in Programming
operating mode ("Saving the datums in the preset table",
page 486).
The input range of the Q parameter list for defining the QPARA tab
on the status display consists of 132 input positions ("Displaying Q
parameters (QPARA tab)", page 82).
Manual calibration of the touch probe with fewer pre-positioning
movements ("Calibrating a 3-D touch trigger probe (option 17)",
page 502).
The position display takes into account the DL oversizes
programmed in the Tool Call block, selectable as an oversize of the
workpiece or tool ("Delta values for lengths and radii", page 169).
In single blocks, the control executes each point individually
with point pattern cycles and CYCL CALL PAT ("Program run",
page 551).
Rebooting the control is no longer possible with the
END key, but
with the soft key ("Switch-off", page 466).
The control displays the contouring feed rate in manual mode
("Spindle speed S, feed rate F and miscellaneous function M",
page 479).
Deactivate tilting in manual mode is only possible via the 3D-ROT
menu ("To activate manual tilting:", page 526).
The machine parameter maxLineGeoSearch has been increased
to a maximum of 50000 ("Machine-specific user parameters",
page 596).
The names of Software Options 8, 9 and 21 have been changed