Grass Valley Profile XP Aug 16 2004 - Manual (Page 268)

Chapter 11 Setting up a Simple Network
268 Profile XP System Guide 23 July 2004
Power-off and connect proper cabling
The Ethernet connector for Windows NT networking is an RJ-45 connector located on
the rear panel as shown. Ethernet cables are provided with your Profile XP system. If
these cables are not used, be sure to refer to Appendix B, “Connector Pin-outs” for
cabling specifications and pinouts.
You can connect your Profile XP systems together using an Ethernet hub or switch. An
Ethernet hub is used in most simple Ethernet networks.
0624-27
Profile XP Media Platform
From Ethernet
network hub or
switch.
0624-30
Profile1
Profile2
Profile3 Windows NT
Network
Ethernet Hub
or Switch