Grass Valley Profile XP Aug 16 2004 - Manual (Page 231)

Select a timecode source for timecode burn-in
23 July 2004 Profile XP System Guide 231
Select a timecode source for timecode burn-in
After enabling the timecode burn-in on the optional Video Monitor board, you must
select a timecode source for the Video Monitor output using Channel Configuration
dialog box. (For information on enabling the timecode burn-in, see “Enabling Video
Monitor timecode burn-in” on page 188.)
To select timecode source for the Video Monitor burn-in:
1. Select Channel Configuration in the Configuration Manager window.
2. Click the tab for the channel you want to configure.
3. Click on a timecode track in the configuration tree, or click Add Track to add a new
one.
4. Click the Crosspoints button, then select the Video Monitor output listed in the
Timecode Output list.
NOTE: The Video Monitor is displayed in the Timecode Output list when it is
assigned to the channel as a video output. For example, MonitorTC-OutA-J11, is
listed in the following figure because Monitor-OutA-J11 is selected as a video
output for the channel. Refer to “Selecting the video I/Os used by a channel” on
page 157 for instructions on selecting the video outputs for a channel.
5. Click Finish to save your settings.