Enabling video monitor timecode burn-in – Grass Valley Profile XP Aug 16 2004 User Manual
Page 188
Chapter 5 Modifying a Channel: Video Settings
188
Profile XP System Guide
23 July 2004
7. Select another video monitor output to modify, or click
Finish
to saving your
settings.
Enabling Video Monitor timecode burn-in
You can enable timecode burnin on the Video Monitor outputs. Once enabled, you must
select a source of timecode for the Video Monitor output. To select the source of
timecode source, refer to “Selecting the video output as a timecode output for the
channel” on page 225.
To configure timecode burn-in:
1. Select
Video Monitor
in the Configuration Manager window. The Video Monitor
dialog box appears.
2. Click
Next
to navigate to Video Monitor page 2 of 2.
3. Choose a monitor output in the Video Monitor Setup list or click
Select All
.
4. Select the
Show Time Code
check box.
5. Select the text line number using the drop-down lists.
Twelve text lines are available for small text. Six lines are available for large text.