Grass Valley Profile XP Aug 16 2004 - Manual (Page 106)

Chapter 3 Working with RAID Storage Using GVG Disk Utility
106 Profile XP System Guide 23 July 2004
Checking PFR500 disk settings
You can check disk drive settings to verify that they are set to factory default and are
appropriate for operation in Profile XP installations.
To check disk drive settings:
1. In the GVG Disk Utility tree view, right-click the RAID Controller node, then
select Advanced | Check Disk Settings in the context menu.
2. On receiving a message, click OK .
Settings are reported as “correct” or “incorrect”. If disk settings are reported as
incorrect, refer to “Restoring PFR500 disk settings” on page 106.
Restoring PFR500 disk settings
If for any reason, the disk drive settings are inappropriate for operation in Profile XP
installations, they must be restored to default. To check disk drive settings, refer to
“Checking PFR500 disk settings” on page 106.
To restore disk drive settings:
1. In the GVG Disk Utility tree view, right-click the RAID Controller node, then
select Advanced | Restore Disk Settings in the context menu.
2. On receiving an operation successful message, click OK .
All disk settings are now correct.
3. Reboot the RAID storage and Profile XP media platform using the “System reboot
procedure” on page 94.
NOTE: If your PFR500 is part of an Open SAN, disregard the previous step, and
refer to the instructions in the Open SAN Instruction Manual for powering-off and
powering-on the Open SAN.