Grass Valley Profile XP Aug 16 2004 - Manual (Page 262)

Chapter 11 Setting up a Simple Network
262 Profile XP System Guide 23 July 2004
Choosing machine names and IP addresses for your Fibre Channel network
The default machine name for each Profile XP system is the unit serial number. You may
want to change the name to something more meaningful, such as
Profile1 or Profile2 .
The video network option also requires you to set up two IP addresses for each
Profile XP unit, one for the Ethernet interface and the other for the Fibre Channel
interface. A common mistake is to choose IP addresses for the Fibre Channel and
Ethernet interfaces using the same network ID. This is wrong; the IP addresses for each
network must be unique.
Here is an example of IP addresses for two Profile XP systems:
Computer Name: Profile1
Ethernet Address: 192.168.99.1
FC Address: 192.168.100.1
Computer Name: Profile2
Ethernet Address: 192.168.99.2
FC Address: 192.168.100.2
You can use the these addresses if you want, but if you are connecting the Ethernet
interface to an existing network, check with your system administrator for the correct
names and IP addresses to use.
Use the table below to enter information you’ll need when you configure your video
network.
Refer to the procedures in “Setting up a simple video network: Fibre Channel” on page
270, when you to set up the Fibre Channel video network.
Machine Name Ethernet IP Address Fibre Channel IP
Address