H3C Technologies H3C S10500 Series Switches - Manual (Page 85)

75
Model Description Ports
Compatible
transceiver modules
LSQ1ACGASC
0 Application control
gateway module
• 1 × console port
• 1 × CF card slot (supporting 256-MB,
512-MB, and 1-GB CF cards)
• 2 × USB port
• 2 × 10/100/1000BASE-T copper port
• 2 × GE combo interface
• Category 5
twisted pair cable
• GE SFP module
LSQ1LBSC0
Load balancing
module
• 1 × Console port
• 1 × CF card slot (supporting a 256-MB,
512-MB, or 1-GB CF card)
• 2 USB port
• 2 × 10/100/1000BASE-T copper port
• 2 × GE combo interface
• Category 5
twisted pair cable
• GE SFP module
Restrictions and guidelines
Follow these restrictions and guidelines to use the LPUs:
• The LSUM2GV48SE0 interface card is supported only by the S10506 and S10510 switches.
• The LSQ series OAA cards are supported only by the S10504, S10506, S10508, S10508-V, and
S10512 switches. For the OAA cards to successfully start up, make sure a minimum of one switch
fabric module is installed in either of the two lowest numbered switching fabric module slots.
• Do not install any of the following cards in slots 4 to 9 on the S10510 switch:
{
LSU1GP24TSE0/LSU1GP24TXSE0/LSU1GT48SE0/LSU1GP48SE0/LSU1TGX4SE0/LSU1GP
24TSE0
{
LSU1GP24TXEA0/LSU1GP48EA0/LSU1GT48EA0/LSU1TGX4EA0
{
LSU1GP48EB0/LSU1GP24TXEB0/LSU1TGX4EB0
{
LSUM1SPMAEC0
{
All OAA cards
• Cards supported by the S10506 switch vary by the forwarding mode of the slots, as shown in Table
27 . For information about the forwarding modes, see H3C S10500 Switch Series Fundamentals
Configuration Guide.