beautypg.com

H3C Technologies H3C S10500 Series Switches User Manual

Page 50

background image

40

Connecting your switch to the network through optical fibers

WARNING!

To avoid injury to your eyes, do not stare at the optical ports and optical fiber connectors when connecting
optical fibers.

You can install a transceiver module (see "

Installing FRUs

") in a fiber port and use optical fibers to

connect the port to the network. For more information about optical fibers, see "Appendix D Cables."
To connect a fiber port to a peer device through optical fibers:

1.

Install a transceiver module into the port.

2.

Remove the dust cover of the optical fiber connector, and clean the end of the optical fiber.

3.

Remove the dust plug of the transceiver module, connect one end of the optical fiber to the
transceiver module, and connect the other end to the transceiver module in the peer device.

{

For how to connect an LC connector, see

Figure 40

.

{

For how to connect an MPO connector, see

Figure 41

.

4.

Examine the port LEDs for incorrect connection.
For more information about the LED status, see "

Appendix C LEDs

."

NOTE:

For the QSFP+ module, you do not need to differentiate between the transmitter (TX) and receiver (RX)
ports. For other types of transceiver modules, the Tx port on one end must connect to the RX port on the
other end.

Figure 40 Using an LC optical fiber connector to connect an SFP module

LC plug

SFP module