H3C Technologies H3C S10500 Series Switches - Manual (Page 22)

12
Figure 7 Installing a cage nut
4. Align the installation holes on the front end of a slide rail with the cage nuts on the front rack post,
and attach them with screws, as shown in
Figure 8 .
Figure 8 Attaching a slide rail to a front rack post
5. Keep the slide rail horizontally and adjust its length until the installation holes on the rear end of the
slide rail touch the cage nuts on the rear rack post. Then fasten the screws.
Install a screw in each mounting hole of the slide rail to ensure its weight bearing capacity.
6. Repeat steps 4 and 5 to install the other slide rail. Make sure the two slide rails are at the same
height so that the switch can be placed on them horizontally.
Figure 9 shows the installed slide
rails.