Repackaging the switch accessories, Repackaging the power modules, Figure 100 – H3C Technologies H3C S10500 Series Switches User Manual
Page 134: And then remove the

124
Figure 100 Removing the grounding cable (S10506)
Removing the twisted pair cables and optical fibers
You must remove all twisted pair cables and optical fibers from the interfaces of the switch.
NOTE:
After pulling out an optical fiber from an optical transceiver module, cover the connector of the optical
fiber with a dust cap to keep the connector clean.
Repackaging the switch accessories
Repackaging the power modules
CAUTION:
Before removing power modules, switch off the circuit breakers at the input ends of all power cords, and
remove all the power cords to avoid device damage and bodily injury.
To repackage the power modules:
1.
Prepare the packing bag and box for each power module. Make sure the bag and box is clean,
dry, and not damaged.
2.
Remove all power modules from the chassis, and then install blank filler panels in the empty slots.
For how to remove a power module and install a blank filler panel, see "
3.
Put each power module into the bag.