H3C Technologies H3C S10500 Series Switches - Manual (Page 137)

127
b. Insert the bolt through the mounting hole from the bottom of the wooden pallet base until the
bolt reaches out the mounting hole from the top of the wooden pallet base.
c. Attach another washer and two nuts to the bolt in sequence.
d. Fasten the nuts.
Figure 103 Attaching the L-type brackets to the wooden pallet base
(1) L-type bracket (2) Bolt
5. Cover the chassis with the packing bag from the top down, and then tape the bag to the plastic
cover of pallet base.
6. Cover the foam cushion to the chassis top, and make sure the mounting brackets seat into the
internal notches of the foam cushion. See Figure 104 .
7. Put the box of packed accessories into the notch of the foam cushion that is near to the rear end of
the chassis, as shown in
Figure 104 .
8. Erect one paper angle bead along each vertical edge of the chassis, and use the carton to cover
the chassis from top down with the silkscreen side facing the front panel of the chassis.
9. Cover the top cap to the carton. Skip this step for the S10504 and S10506.
1
2