beautypg.com

Setting up a poe system (optional), Requirements – H3C Technologies H3C S10500 Series Switches User Manual

Page 36

background image

26

To connect the power cord:

1.

Plug the power cord into the power receptacle of the power module.

2.

Fasten the screw to secure the power cord.

Figure 24 Connecting the power cord (vertical slot)

3.

(Optional) Use a cable tie to secure the power cord to the cable management bracket. For more
information, see

Figure 22

and

Figure 23

.

4.

Connect one end of the DC power cord marked with –48V to the negative terminal (–48V) on the

power source; connect the DC power cord with RTN end to the positive terminal (RTN).

Setting up a PoE system (optional)

Requirements

Power over Ethernet (PoE) enables a power sourcing equipment (PSE) to supply power to powered

devices (PDs) through power interfaces (PIs) over twisted pair cables. Commonly used PDs include IP

telephones, APs, and web cameras.
To set up a PoE system, the following components are required:

A switch that supports PoE—The S10506 or S10510 switch.

An external PoE power frame—The PSE16KA0. For how to install the PSE16KA0, see "

Connecting

an external PoE power frame

."

PSEs—The LSUM2GV48SE0 cards.

Table 7 LSUM2GV48SE0 specifications

Item Specification

PD class

Classes 0 to 4

Maximum power

800 W

PI quantity

48 (RJ-45 ports)

PI power

0 W to 30 W

Output voltage range

50 VDC to 57 VDC

Maximum output current

600 mA