H3C Technologies H3C S10500 Series Switches - Manual (Page 25)

15
Mounting the switch in the rack
CAUTION:
•
Do not hold the handle of the fan tray or power module, or the air vents of chassis to move the switch.
Any attempt to carry the switch with these parts might cause equipment damage or even bodily injury.
• After placing the switch on the slide rails, do not leave go of your hands immediately because this might
tip the switch, damaging the switch or even causing bodily injury.
To mount the switch in the rack:
1. Move the chassis to face the rear of the chassis towards the front of the rack.
2. Use a minimum of two people to lift the switch by using the chassis handles or supporting the
bottom of the chassis until the bottom of the switch is a little higher than the slide rails on the rack.
H3C recommends using a mechanical lift for moving your switch.
3. Place the switch on the slide rails and slide the switch along the slide rails until the mounting
brackets on the switch touch the front rack posts, as shown by callout 1 in
Figure 11 .
4. Attach the chassis to the rack with mounting screws.
Figure 11 Installing the chassis in the rack (S10506)
If the mounting holes in the mounting brackets cannot align with the cage nuts on the rack, verify that the
bottom edge of the slide rail aligns with the middle of the narrower metal area between holes and that
the cage nuts are installed in the correct holes.
Grounding the switch
CAUTION:
Before you use the switch, connect the grounding cable correctly to guarantee lightning protection and
anti-interference of the switch.