H3C Technologies H3C S10500 Series Switches User Manual
Page 48

38
Turn on the power source of the switch to power on the switch.
The following is a sample output you can see on the terminal:
System is starting...
Booting Normal Extend BootWare.
The Extend BootWare is self-decompressing...................................
.....Done!
****************************************************************************
* *
* BootWare, Version 1.32 *
* *
****************************************************************************
Compiled Date : Mar 11 2014
CPU Type : XLP316
CPU Clock Speed : 1200MHz
Memory Type : DDR3 SDRAM
Memory Size : 8192MB
Memory Speed : 667MHz
BootWare Size : 1536KB
Flash Size : 500MB
BASIC CPLD Version : 3.0
EXTENDED CPLD Version : 3.0
PCB Version : Ver.A
BootWare Validating...
Press Ctrl+B to enter extended boot menu...
Starting to get the main application file--flash:/ S10500.bin!................
.........................................................................
The main application file is self-decompressing.............................
............................................................................
..Done!
System application is starting...
Starting to get the main application file--flash:/ S10500.bin!................
..........................................................................
The main application file is self-decompressing.............................
............................................................................
............................................................................
.....Done!
System application is starting...
User interface aux0 is available.
Press ENTER to get started.
Press Enter at the prompt. When the prompt
appears, you can configure the switch.
After powering on the switch, check the following items:
•
The cooling system is working, and you can hear fan rotating noise and feel air being blown out.
•
The system status LEDs on the MPUs show that the system is operating correctly. For more
information about LED behaviors, see "