Connecting an sfp+/qsfp+/qsfp+ to sfp+ dac cable – H3C Technologies H3C S10500 Series Switches User Manual
Page 44
34
3.
Holding both sides of the module, gently push the module into the slot until it has firm contact with
.
4.
Fasten the captive screws.
5.
Connect the fiber to the module. For the installation procedure, see "
."
Figure 35 Installing a CFP module
Connecting an SFP+/QSFP+/QSFP+ to SFP+ DAC cable
Use the SFP+, QSFP+, and QSFP+ to SFP+ DAC cables to connect ports as follows:
•
Use SFP+ DAC cables to connect SFP+ ports.
•
Use QSFP+ DAC cables to connect QSFP+ ports.
•
Use QSFP+ to SFP+ DAC cables to connect QSFP+ and SFP+ ports.
All these cables are hot swappable.
To connect an SFP+, QSFP+, or QSFP+ to SFP+ DAC cable:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded. For
more information, see "
."
2.
Unpack the cable.
3.
Plug the cable connector into the port. Make sure the cable connector is the right side up.
The bend radius of the cable must be a minimum of eight times the cable diameter.
Figure 36 Connecting an SFP+ DAC cable
(1) Pull latch
(2) Connector