H3C Technologies H3C S10500 Series Switches - Manual (Page 83)

73
NOTE:
•
A combo interface is a logical interface that contains an SFP port and an RJ-45 Ethernet port. Only one
of them can be activated at a time.
• The Ethernet copper ports on the LSUM2GV48SE0, LSUM2GT48SE0, LSUM2GT24TSSE0, and
LSUM2GT24PTSSE0 cards and all fiber ports cannot be configured or automatically negotiated to
operate in half-duplex mode. For more information about the duplex mode of Ethernet interfaces, see
H3C S10500 Switch Series Fundamentals Command Reference.
• For information about the transceiver modules available for the interface cards, see " Appendix D
Transceiver modules ."
Base cards
Table 24 Base card specifications
Model Subcard slots Description
LSUM1SPMAEC0 4 Multi-service base card
Subcards
You must install the subcards in base cards.
The LSR1DRUP1L1 subcards must be installed in both slots 1 and 2 of an LSUM1SPMAEC0 base card.
To connect two subcards in different S10500 switches, connect the subcard in slot 1 on one base card
to that in slot 2 on the other-end base card, or vice versa.
Table 25 Subcard specifications
Model Description Connector
Number of
ports
Available
transceiver modules
and cables
LSR1DRUP1L1
1-port
OC192c/STM64c-XFP
optical interface card
LC 1 10-GE XFP module
InfiniBand 4X 1
InfiniBand high-speed
cable
OAA cards
Table 26 OAA card specifications
Model Description Ports
Compatible
transceiver modules
LSU3WCMD0
High-performance
access controller
module
• 1 × console port
• 1 × CF card slot (supporting 256-MB,
512-MB, and 1-GB CF cards)
• 2 × USB port
• 2 × 10/100/1000BASE-T copper port
• 2 × GE combo interface
• Category 5
twisted pair cable
• GE SFP module