H3C Technologies H3C S10500 Series Switches - Manual (Page 102)

92
Appendix D Transceiver modules
CAUTION:
To avoid damages to the transceiver, a compatible optical attenuation must be used if a short-haul optical
fiber is connected to a long-haul transceiver (40 km/24.86 miles or above). A loopback occurs if you
connect the receive optical bore to the transmit optical bore with a short-haul optical fiber, as shown
in
Figure 70 .
Figure 70 Loopback operation on a transceiver module
The S10500 Switch Series supports the following transceiver modules and cables:
• 100-GE/40-GE CFP transceiver modules
• 40-GE QSFP+ transceiver modules
• 40-GE QSFP+ DAC cables
• 10-GE XFP transceiver modules
• 10-GE SFP+ transceiver modules
• 10-GE SFP+ DAC cables
• 1000/100 Mbps SFP transceiver modules
100-GE/40-GE CFP transceiver modules
Table 57 100-GE/40-GE CFP transceiver module specifications
Model
Central
wavelength
Connector Fiber
Max transmission
distance
CFP-100G-LR4-WD
M1300-A
1295.56 nm LC 9/125 μm single-mode fiber 10 km (6.21 miles)
1300.05 nm LC 9/125 μm single-mode fiber 10 km (6.21 miles)
1304.58 nm LC 9/125 μm single-mode fiber 10 km (6.21 miles)
1309.14 nm LC 9/125 μm single-mode fiber 10 km (6.21 miles)
CFP-40G-LR4-SM13
10 (LSUM1CFP0)
1310 nm LC 9/125 μm single-mode fiber 10 km (6.21 miles)