Welltech SIPPBX 6200 V.3.1.1 - Manual (Page 90)

Welltech Technology Co., Ltd.
SIPPBX 6200S, 6200GS, 6200N Release 3.1.1
User Guide
- 90 -
Figure 6.13-2
Parameter Description:
Personal Screening Service:
• Personal ANI Screening: Personal ANI screening can be used to filter the
caller based on caller ID. For all Telephone are set to allow (full match),
only on-list ANI can go through. For all TEL are set to disallow, only on-list
ANI will be screened. Otherwise, “disallow” has higher priority than “allow”.
• Personal DNIS Screening: Personal DNIS screening can be used to limit
the called prefix. For all TEL are set to allow (prefix match), only on-list
DNIS can go through. For all TEL are set to disallow, only on-list DNIS will
be screened. Otherwise, “disallow” has higher priority than “allow”
Subscriber Service:
• ANI Replacement: Replace calling number for Gateway Only or All
subscribers.
- Replace ANI: Replace calling number. It is used to integrate an PSTN
number into VOIP number. When the PSTN phone receiver get Caller
number from Caller ID, receiver may call back this reachable PSTN
number to call back. Since Caller use IP-PBX extension to call, only
replace an reachable PSTN number for receiver to Call back.
- Replace Type: Whether to replace the calling number to Gateway Only
(for instance: FXO, E1 gateway and IP SIP Trunk) or All (include
extensions) or not.
- PSTN Number: Once you have activated Replace ANI, the receiver
only see replaced ANI via Caller ID. Once PSTN Number was selected,
receiver call back this number (Replace ANI) will reach to original
number.
• Display Name: Change SIP signal field display name to an readable name
which may display at IP phone. This name can be an word or number but it
can’t be regarded as call back number.
• Server Transfer: The server will do the transfer instead of CPE. It is
recommended to use it only when CPE doesn’t support call transfer
features. There are 4 options: Transferee Only, Transfer Only, Both or
None.