Welltech SIPPBX 6200 V.3.1.1 - Manual (Page 22)

Welltech Technology Co., Ltd.
SIPPBX 6200S, 6200GS, 6200N Release 3.1.1
User Guide
- 22 -
setting IVR. The call flow of Service Setting IVR can be programmed by an
Call Flow Editor which was implemented by an graphic editor with Drag and
Drop tool. User can dial this prefix code and IVR will response to guide for
setting the service.
• VMS Access Code 1: When you use this extension to dial VMS access code
1, it retrieves this extension’s voice mail automatically. No extension number
needs to enter.
• VMS Access Code 2: Will ask for entering desirable extension number and
password authentication to access its voice mail.
• Leave VMS Directly Prefix: This is the prefix code to be used for entering the
left message directly without prompt. The system will automatically create the
required prefix. The users only need to dial this prefix and extension number
to leave a message. It is useful for an IP-PBX operator to transfer an
incoming call to leave a voice mail to that extension.
• Conference Prefix: An public Conference Service room. Each extension can
dial this prefix code to enter this conference room to talk.
• Virtual Conference Prefix: Virtual conference prefix code. A conference room
which was established by extension. To enter specific extension’s conference
room, dial prefix code + extension number .
• Wakeup Call Prefix: Wakeup call service prefix code.
• FAX Prefix: The prefix of the FAX Service. The Extension can receive the FAX
service by the following ways.
1. FAX in through Auto Attendant: The remote Caller dials Auto Attendant
number of SIPPBX 6200x first then continue dialing “FAX
Prefix+Extension” and press start key of FAX machine to start
transmission.
2. Direct Fax in number: Create a new extension (i.e. FXS gateway) as the
fax DID number and enable unconditional forward to “ FAX
Prefix+Extension ”.
The remote Caller can send fax by dialing this fax number directly.
The received FAX messages will be converted as PDF format. The fax
message can be retrieved through web interface or send an email to the
users with PDF attachment.
• Call Authentication PIN prefix : This feature is used to redirect an incoming
call from PSTN network (i.e. FXO or E1 gateway) to another line of PSTN
network via IVR’s prompt to authenticate PIN prefix. To enable this feature, an
relevant IVR Call Flow has to program first. IVR will ask dialer to enter PIN
code to redirect your call to PSTN line. To activate this feature, the Transit
Call feature has to be enabled as well. See figure 3.4-4.
Step 4: Choose the minimum reserved resource according to your purchased
Enhance License. Go to SIPPBX 6200x webpage at System Core  License 
Enhance License to check your resources which was defined by License. See
Figure 3.2-4 at RED box which indicates Enhance License resources is 24.
According to your purchased model and license, there are several Enhance
License as follows.
SIPPBX 6200S : 12, 16 and 24.
SIPPBX 6200GS : 12, 16, 24, 32 and 48.
SIPPBX 6200N : 24, 36, 48, 60, 72, 84, 96 and 120.