Welltech SIPPBX 6200 V.3.1.1 - Manual (Page 84)

Welltech Technology Co., Ltd.
SIPPBX 6200S, 6200GS, 6200N Release 3.1.1
User Guide
- 84 -
• Number Change: Change the original number to a new number. When
enable this feature, the IP-PBX system will play announcement to the
changed number.
• Auto Call Forward: Auto Call Forward feature is available when Number
Change was enabled.
Call Pickup :
• Group Pickup (Picked): Allowed to be picked-up within the same group
only.
• Global Pickup (Picked): Allowed to be picked-up globally (from different
Group).
Personal Screening Service :
• Personal ANI Screening: Personal ANI screening can be used to filter the
caller based on caller ID. For all TEL are set to allow (full match), only
on-list ANI can go through. For all TEL are set to disallow, only on-list ANI
will be screened. Otherwise, “disallow” has higher priority than “allow”.
• Personal DNIS Screening: Personal DNIS screening can be used to limit
the called prefix code. For all TEL are set to allow (prefix code matched),
only on-list DNIS can go through. For all TEL are set to disallow, only on-list
DNIS will be screened. Otherwise, “disallow” has higher priority than “allow”
• Do Not Disturb: Up-to 2 time segments can be set to reject incoming calls.
VAD Service (Value Added Service)
• Coloring Ring Back Tone: Enable Coloring Ring Back Tone service.
• VMS: Enable Voice Mail Service.
• Server Hold Tone: Enable Server Hold Tone or not. When you enable it, the
SIPPBX 6200x will play the hold tone music instead of CPE device hold
tone.
• Announcement Service: Enable the announcement service or not. Normally,
you don’t need to enable it because Office Profile will enable voice mail
service.
Subscriber Service
• ANI Replacement: Replace calling number for Gateway Only or All
Subscribers.
- Replace ANI: Replace calling number. It is used to integrate an PSTN
number into VOIP number. When the PSTN phone receiver get Caller
number from Caller ID, receiver may call back this reachable PSTN
number to call back. Since Caller use IP-PBX extension to call, only
replace an reachable PSTN number for receiver to Call back.
- Replace Type: Whether to replace the calling number to Gateway Only
(for instance: FXO, E1 gateway and IP SIP Trunk) or All (include
extensions) or not.
- PSTN Number: Once you have activated Replace ANI, the receiver
only see replaced ANI via Caller ID. Once PSTN Number was selected,
receiver call back this number (Replace ANI) will reach to original
number.
• Short Code: Short code is to be used within the same group. In the same
office extension plan, complete extension number digits include prefix
code+number. For instance, 0702069629 which is completed number to