Welltech SIPPBX 6200 V.3.1.1 - Manual (Page 71)

Welltech Technology Co., Ltd.
SIPPBX 6200S, 6200GS, 6200N Release 3.1.1
User Guide
- 71 -
over than it.
Device Auto Configuration
The SIPPBX 6200x provided the Extension Device Auto Configuration feature.
System Administrator can manage the extension device easily without setup.
Most of setting can be automatic provisioned to CPE (Support LP600N IP Phone
only) . Here you can set the Extension Auto Configuration parameters.
The following parameters will be provisioned to
- SIPPBX discovery (when using VLAN and DHCP)
- Telephone number and PBX related setting
- Access code required for LP600N
- Office and personal phone book
- Office dialing plan
- Common Device Configuration
- Firmware Upgrade
The most settings were full integrated into SIPPBX configuration. Here is for the
device (LP600N)’s common configuration and firmware upgrade.
Start Path: Enhance Service > Config > Device Auto Configuration
Figure 6.10-1
Device Cfg:
This is the place to upload the device configuration setting file. Please get the
CPE template file from Welltech Technical Support webpage and modify when it
was necessary. The current model supported by SIPPBX 6200x is LP600N
IP-Phone and the configuration file need to be lp600n.cfg. In the lp600n.cfg,
there is a parameter to indicate the firmware name. When the firmware name
was different from the existing LP600N’s, the LP600N will automatically upgrade
it.
Firmware File:
Here is the place to upload the firmware file for LP600N. Once you setup a
new firmware in lp600n.cfg, you need to upload the corresponding firmware to
SIPPBX 6200x for LP600N to upgrade.
Office Profile
SIPPBX 6200x can support headquarter and multiple branch offices
simultaneously. Each office can have different setting including PSTN incoming
number, greeting language and call flow when you have installed an FXO
gateway.