Verilink WANsuite 5370 (34-00310.D) Product Manual - Manual (Page 73)

W e b S e r v e r I n t e r f a c e 3-43
NOTICE: If you change the Service parameter, you must click on “Submit” to see
the appropriate DLCIs.
The Service Aware screen provides a “Clear Alarms” user-activated button at
the bottom of the screen.
Rule Details Screen
Use the Rule Details screen () to establish Service Aware parameters. To
access the screen, click on the appropriate number under the “Index” column
on the Service Aware screen. To establish a rule, you must select the desired
rule configuration options and provide the appropriate filter information where
required. Then press the “Submit” button at the bottom of the screen.
Rule Config Screen
The paragraphs below describe the rule configuration parameters and their
options.
Service Selects the service to which the rule applies. Select from a pull-down list of
available services.
NOTICE: If you change the Service parameter, you must click on “Submit” to see
the appropriate DLCIs.
DLCI Selects the DLCI to which the rule applies. Select from a pull-down list of
applicable DLCIs.
Filter By DLCI Enables or disables filtering of the IP traffic by the DLCI specified in the
DLCI pull-down list.
NOTICE: To use this filter, you must specify both the Service and DLCI
parameters in the rule configuration.