beautypg.com

10/100 ethernet (ip service details) screen, 10/100 ethernet (ip service details) screen -11 – Verilink WANsuite 5370 (34-00310.D) Product Manual User Manual

Page 41

background image

W e b S e r v e r I n t e r f a c e

3-11

To make changes to any Auxiliary port parameter, simply set the parameter to
the desired selection and click the “Submit” button at the bottom of the
screen.

10/100 Ethernet (IP Service Details) Screen

The 10/100 Ethernet (IP Service Details) screen (Figure 3.7) lets you
configure the IP parameters listed below.

Figure 3.7

10/100 Ethernet (IP Service Details) Screen

Unit IP Address

A unique network address assigned to this unit.

Subnet Mask

Defines the network portion of the unit’s IP address.

Gateway IP Address

IP address of the default gateway (router) on the LAN side of the unit.

DHCP Client

If DHCP Client is enabled at power-up, the unit will request its IP, Mask, and
Gateway addresses from a DHCP server located on the LAN side of the unit,
and the unit will use these addresses. If the DHCP request is unsuccessful, the
unit will use the configured addresses shown on this screen.

NOTICE:

Always verify that a DHCP server is available on the network before
enabling DHCP Client. If, on power-up, a DHCP server is not found, a
60-second timeout will occur.

Client Identifier

Displays a unique identifier for a specific IP address.

Ethernet

Enables or disables a remote unit’s Ethernet port.

Physical Address

Displays unique MAC address.

This manual is related to the following products: