Verilink WANsuite 5370 (34-00310.D) Product Manual - Manual (Page 146)

4-30 W A N s u i t e 5 3 7 0
To change the Username and Password for a selected PAP Index, enter the
new information in the appropriate field(s) and press the “Esc” key.
To delete the Username and Password for a selected PAP Index, delete the
character string displayed in both fields (leaving them blank) and press the
“Esc” key.
CHAP Table and Details Screens
From the PPP Service Details screen, select “CHAP Table” to view a table of
the CHAP Username and Secret information for each of 10 entries. This table
and its Details screen look the same as the PAP Table and Details screens.
IP Service Details Screen
The IP Service Details screen (Figure 4.10), accessed by selecting “IP” from the
column in the IP Service screen, lets you configure the IP parameters
described on page 4-13.
To change any of the available parameters, you must enter new values in the
appropriate field(s) and press the “Esc” key to save your changes.
NOTICE: To use newly established IP parameters, you must “Save and Restart.”
(See "Save and Restart" on page 4-6.)
SCADA Service Details Screen
NOTICE: SCADA traffic has a higher priority than other types of traffic flowing
through the unit. Refer to Normal Tx Queue Size on page 4-23 for more
details.
The SCADA Service Details (Figure 4.26) screen lets you access and read or
change the parameters listed below.
Figure 4.26 SCADA Service Details Screen