Verilink WANsuite 5370 (34-00310.D) Product Manual - Manual (Page 42)

3-12 W A N s u i t e 5 3 7 0
NOTICE: If you manually change the IP address, you must “Save and Restart.”
(See Save and Restart on page 3-4.) The first three address parameters
above can also be configured using the Installation Wizard on page 2-2.
To view details about the current condition of IP, ICMP (In and Out), TCP,
and UDP parameters, click the “Ethernet Stats” button at the bottom of the
screen. The Ethernet Statistics screen (Figure 3.8) contains no user-selectable
fields or options; it is simply a representation of the applicable MIB II
parameters.
Figure 3.8 Ethernet Statistics Screen
Click on the Unit Access Table button on the Ethernet (IP Details) screen to
view the Unit Access Table (Figure 3.9), which specifies up to 10 different IP
networks that may access the unit’s parameters. If no IP networks are
supplied, any host may access the unit. Select any Index number on the table
to view the Unit Access Details (Figure 3.10) that correspond with that Index
number.