Verilink WANsuite 5370 (34-00310.D) Product Manual - Manual (Page 131)

V T 1 0 0 I n t e r f a c e 4-15
Figure 4.13 Supervisory Config Screen
The Supervisory screen lets you view and change the Supervisory port speed
used by PPP and VT100. The Supervisory port only supports asynchronous
character formats.
Speed Changes the Supervisory port speed (in bits per second).
Values: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
Default: 19200
Character Size Selects the number of bits required to make up one asynchronous character.
Values: Five, Six, Seven, Eight
Default: Eight
Parity Selects the parity bit.
Values: None, Odd, Even
Default: None
Stop Bit Selects the number of bits required to end the character.
Values: 1, 2
Default: 1
DTR Alarm Control Setting DTR Alarm Control to “Enable” allows the unit to go into alarm on a
loss of DTR.
Values: Disable, Enable
Default: Disable
DTR Alarm Status Indicates the current state of the DTR alarm.
Diagnostic Msgs Enables the Supervisory port to send out diagnostic messages upon power-up.
Values: Enable, Disable
Default: Enable
NOTICE: When in SCADA mode, these diagnostic messages disrupt the connected
device. Therefore, if using the SCADA mode, set this value to
“Disable.”