Verilink WANsuite 5370 (34-00310.D) Product Manual - Manual (Page 226)

B-2 W A N s u i t e 5 3 7 0
• rfc1573.mib
−
defines the IANAifType textual convention, and thus the
enumerated values of the ifType object defined in MIB-II’s
ifTable
• rfc2863.mib
−
describes generic objects for network interface sub-layers
(This MIB is an updated version of MIB-II's ifTable, and
incorporates the extensions defined in RFC 1229.)
•
rfc2493.mib
−
provides textual conventions to be used by systems
supporting 15-minute based performance history counts
• rfc2115.mib
−
describes the use of a Frame Relay interface by a DTE
•
rfc2495.mib
−
describes DS1, E1, DS2 and E2 interfaces objects
•
rfc2011.mib
−
for managing IP and ICMP implementations, but excluding
their management of IP routes
• rfc2012.mib
−
for managing TCP implementations
• rfc2013.mib
−
for managing UDP implementations
• rfc2096.mib
−
for the display of CIDR multipath IP routes
•
rfc2571.mib
−
the SNMP Management Architecture MIB
The WANsuite 5370 supports the following Enterprise-specific MIBs:
• ds8200tc.mib
−
textual conventions used by DS8200 MIB
•
ds8200v2.mib
−
provides T1 configuration and statistics information
•
ipadv2.mib
−
provides Frame Relay, PPP, and Service Aware
configuration and statistics
• ipstart.mib
−
MIB module for synchronous PPP Monitor
• router.mib
−
provides configuration of OSPF router
• hdsl2.mib
−
MIB module for HDSL
•
ipaddhcp.mib
− ΜΙΒ
module for DHCP
•
ipadnat.mib
−
MIB module for NAT
These MIB files may be found on the Verilink Documentation CD included
with the unit.
SNMP Trap Configuration
The WANsuite 5370 supports up to eight IP destinations for SNMP traps.
These may be configured either through the Web interface or through an
SNMP management application. For configuration of these destinations
through an SNMP management application, use a MIB browser to access the
table
trapdest within ipadv2.mib and set the IP addresses of the host
computer running the management application(s). Entering an IP address of
0.0.0.0 will disable the entry.
The following traps are currently defined in the SNMP MIBs supported by
WANsuite. VarBinds heading lists additional information that is sent in the
SNMP trap message to provide details about the event.