Verilink WANsuite 5370 (34-00310.D) Product Manual - Manual (Page 211)

F r o n t P a n e l L C D I n t e r f a c e 5-13
NOTICE: DTE mode requires the use of an optional DTE cable. Refer to
Appendix A,"Specifications," for ordering information.
DSR Data Set Ready can be set to “True,” “False,” or “Internal.” The “Internal”
option sets DSR “On” if the port is enabled and “Off” if the port is disabled.
Values: True, False, Internal
Default: True
DCD The Data Carrier Detect parameter can be set to “True,” “False,” or
“Internal.” If set to “Internal,” DCD is “On” when network carrier is being
received from the remote end, and is “Off” when network carrier is not being
received from the far end.
Values: True, False, Internal
Default: True
CTS The Clear To Send parameter can be set to “True” or “False.” If this
parameter is set to “Internal,” the CTS control lead follows the RTS control
lead from the DTE after a delay of a duration established by the RTS Delay
parameter.
Values: True, False, Internal
Default: True
RTS The Request To Send parameter determines where the unit reads the RTS
signal status from. If set to “Normal,” the unit gets RTS from the Serial pin. If
set to “True,” RTS is always perceived as “On.”
Values: Normal, True
Default: Normal
RTS Delay The RTS Delay parameter determines how long the unit waits before it
changes the level of CTS to match RTS when the CTS parameter is set to
“Internal.”
Values: Normal (~30 ms delay), Long (~100 ms delay)
Default: Normal
Tx Clock Used to select the clock that the unit uses to sample the data transmitted from
the DTE. When set to “Internal,” the data is sampled directly with the
transmit data clock that is also supplied to the DTE as Transmit Clock.
Values: Internal, External
Default: Internal
Rate If the port is running in Packet mode, the Rate must be configured to the
desired port speed. The menu displays the calculated rate in kilobits per
second.
Values: 1200, 2400, 5600, 14400, 19200, 28800, 38400, 56000, 64000
Default: 19200 bps