Verilink WANsuite 5370 (34-00310.D) Product Manual - Manual (Page 31)

W e b S e r v e r I n t e r f a c e 3-1
C H A P T E R
3
C HAPTER 3
W
EB
S
ERVER
I
NTERFACE
The WANsuite 5370 has an innovative, embedded Web-based user interface
(WANsight) for remote configuration and real-time reporting via Microsoft
Internet Explorer 5.0 or higher. Access to the Web server interface and how
the interface is used to configure the WANsuite 5370 unit are described in
detail below.
NOTICE: Verilink recommends the use of Microsoft’s Internet Explorer 5.0 or
higher because if you use other Internet browsers to access the Web
server interface, some screen elements will not display as described in
this manual.
Configuration through the VT100 interface is covered in Chapter 4, and
configuration through the front panel interface is covered in Chapter 5.
Web Server Access
You can access the Web Server interface through any IP connection to the
WANsuite 5370. This connection can be directly through the 10/100 Ethernet
port, PPP over the Serial, Supervisory, or Auxiliary port, or in-band via
encapsulated IP traffic on the Frame Relay circuit.
NOTICE: Any changes to the unit’s configuration MUST be followed by a
“Submit” if there is a “Submit” button on the menu. If you
change the Service Table, you must perform a “Save and
Restart.”
To access the Web server interface, type the unit’s IP address in the browser’s
Address (or Location) field and press the “Enter” key.