Verilink WANsuite 5370 (34-00310.D) Product Manual - Manual (Page 46)

3-16 W A N s u i t e 5 3 7 0
Figure 3.13 Data Line Monitor Config Table
Mode The two modes available are “Analyze” and “Live.” The Live mode lets you
capture data and create a usable text file of the captured data. In Analyze
mode, the packet switch will return the data via the Data Line Monitor Packet
Table (see Figure 3.14) whereas in the Live mode the Data Line Monitor
Packet Table will appear empty for SNMP calls.
Buffer Management Displays whether displayed data is set to “Wrap” or “Stop on Full.”
Service Indicates which service is being monitored.
Enable Displays whether capture is Enabled or Disabled.
Tx/Rx Filter Displays the direction of the captured data.
Pattern Filter Displays the Enable/Disable status of the Packet Filter.
Pattern Displays which specific pattern is being searched for.
Pattern Mask Displays the bits the unit is looking for.
Pattern Offset Displays the offset in the packet that matches the pattern. If the offset is set to
255, the filter will search the packet for the pattern.
Click on the “Data Line Monitor Packet Table” button at the bottom of the
screen to view the table that displays the captured data. The screen shows
about 10 lines of active data, and if a line is selected, the screen will display
further decoded data below.