Verilink WANsuite 5370 (34-00310.D) Product Manual - Manual (Page 225)

S N M P A g e n t B-1
A P P E N D I X
B
A PPENDIX B
SNMP A
GENT
Introduction
This chapter provides specific information for configuring and using the
SNMP agent within the WANsuite 5370.
The WANsuite 5370 incorporates an Ethernet card that provides connectivity
for LAN-based management stations. The embedded TCP/IP Protocol Stack
allows remote access from both private networks and the Internet.
SNMP Configuration Parameters
To access the SNMP agent, you must have an SNMP management
application, such as HP’s OpenView
â
or Sun’s NetManager
ä
. Access to the
agent is controlled by three community strings: read-access, write-access, and
trap-access (the community string sent with an SNMP trap). Configuration of
these community strings within the WANsuite 5370 is accomplished via the
HTTP (web browser) interface (Chapter 3, Web Server Interface) or the
VT100 interface (Chapter 4, VT100 Interface).
The defaults for these strings are “public” for read-access, “private” for write-
access, and “public” for trap-access. Ensure that your SNMP management
application is configured for whatever access strings you use.
SNMP MIBs
The WANsuite 5370 supports the following industry-standard MIB
(management information base) files:
NOTICE: The following is a list of MIBs for all WANsuite products. A specific
MIB may or may not be applicable to this particular product.
•
rfc1907.mib
−
SNMPv2 entities (initial revision published as RFC 1450)