Advanced modes: enable damping mode, Apply these values to all source placements – Teac GigaPulse User Manual
Page 190
190
GigaPulse
™
User Guide
Im
pu
lse
Bu
ild
er-
Att
rib
ut
es
Impulse Builder-Attributes
190
Advanced Modes:
Enable Damping Mode:
When this box is checked, the GigaPulse will flush the energy out of the system for
these impulses when MIDI automation sends damping data.
This mode is normally not recommended unless you are dealing with Sustain Pedal
ambience for an acoustic piano. When enabled, this causes a much more realistic pedal
down effect. Without this feature, GigaPulse would continue to process the piano
audio even after the sustain pedal has been released. Then if the pedal was triggered
again before the impulse time dies down, that remaining audio would still be audible
and new piano notes would mixed in with that in an unrealistic way. This would
also use up a lot of extra unnecessary processing power as well. When “Damping”
is enabled however, the audio is flushed out of the signal path every time the sustain
pedal is released.
Apply These Values To All Source Placements:
Pressing this button will force the advanced settings for the current source placement
set to all the other placements sets.