Teac GigaPulse - Manual (Page 172)

172
GigaPulse
™
User Guide
Im
pu
lse
Bu
ild
er-
So
ur
ce P
lac
em
en
t
Impulse Builder-Source Placement
172
The 0 Based Numbers radio button auto fills by looking for
and substituting numbers in a sequence starting with 0.
(0,1,2,3...)
The 1 Based Numbers radio button auto fills by looking
for and substituting numbers in a sequence starting with
1(1,2,3...)
The Digits edit box specifies the number of digits to look for and replace
Usage Example:
When recording the impulses for Room 6, label the .Wav files Room6_PPPMMM.wav
(I.e. the 9th impulse of placement 3 might be in a file called Room6_003009.wav)
Enter the first impulse of the first placement: Room6_001001.wav , and then non-
specifying
Specify Fill From Local Plc , and execute 2nd Num Sub to fill the wave file and substitute
the “MMM” (the impulse/microphone number). Press the Next’ Source button. Select
Fill From Other Plc , and then 1st Num Sub to fill the placement and substitute the“PPP”
(the placement number). You would specify, “Fill from local Plc”,
The Update Other Source Placements Group:
The Enable All Button enables all source placements. This button is grayed out if all
source placements are already enabled.
The Enable/Fill All Button enables all source placements and auto fills any empty fields
in accordance with the radio button options, below.
If all source placements are already enabled and the fields are all filled, then the Enable/
Fill All Button
The Disable All button disables all source placements. This button is grayed out if all
source placements are already disabled.