Measurement Computing Personal488 rev.3.0 For DOS & Windows 3.Xi - Manual (Page 380)

IV. TROUBLESHOOTING 19. Error Messages
Personal488 User’s Manual, Rev. 3.0 IV-365
74 UNKNOWN DOS DEVICE NAME Driver488 DOS device name not known.
Must create Driver488 DOS device
name with the Make Dos Name
command.
75 UNABLE TO ALLOCATE MEMORY FOR NEW
DEVICE
Ran out of memory. Remove some devices
to restore memory.
76 UNKNOWN SLAVE DEVICE Internal system error. Report to factory.
77 SLAVE DEVICE NOT SPECIFIED Corrupt initialization file. Run the Install
program.
78 UNABLE TO CREATE DOS DEVICE NAME Internal system error. Report to factory.
79 UNABLE TO INITIALIZE DEVICE Corrupt initialization file. Run the Install
program.
80 ATTEMPTED TO REMOVE SLAVE DEVICE Attempt to remove device which is required
for operation by another device.
81 DATA OVERRUN Serial input overflow.
82 (None) (None)
83 FRAMING ERROR Serial data corrupt. Possible incorrect
Serial port configuration.
84 TIME OUT ON SERIAL COMMUNICATION Serial device did not respond.
85 UNKNOWN PARAMETER OF TYPE %d
SPECIFIED :\n %s = %s
Internal system error. Report to factory.
86 BUS ERROR - NO LISTENERS No Listeners found on bus.
87 TIME OUT ON MONITOR DATA Expected terminator was not received.
88 INVALID VALUE SPECIFIED Specified value is invalid for application.
See command for proper value types.
89 NO TERMINATOR SPECIFIED Terminator must be specified. Check
terminator value.
90 NOT AVAILABLE IN 8-BIT SLOT Specified option is not available when the
I/O adapter is fitted into an 8-bit slot.
91 TOO MANY PENDING EVENTS Internal system error. Report to factory.
92 BREAK ERROR Serial receiver detected break.
93 UNEXPECTED CHANGE OF CONTROL
LINES
Handshake lines changed during
transmission.
94 TIME OUT ON CTS Hardware handshake not satisfied within
time out. Check cabling and connected
device.
95 TIME OUT ON DSR Hardware handshake not satisfied within
time out. Check cabling and connected
device.
96 TIME OUT ON DCD Hardware handshake not satisfied within
time out. Check cabling and connected
device.
97 CANNOT SEND EOI WITHOUT DATA Transmission of EOI was requested when
no data was available to send.
98 ADDRESS STATUS CHANGE DURING
TRANSFER
Talker/Listener mode changed during data
transfer, possibly due to activity of
some other device on the IEEE 488 bus.
99 UNABLE TO MAKE NEW DEVICE MakeDevice or CreateDevice was unable to
create a new device, possibly due to the
number of devices which already
existed.
100 (None) (None)
101 COMMAND SYNTAX ERROR: % Command interpreter was unable to
interpret command and no other
information was available.