Measurement Computing Personal488 rev.3.0 For DOS & Windows 3.Xi - Manual (Page 319)

15A. Driver488/DRV Commands III. COMMAND REFERENCES - 15. Command References
III-304 Personal488 User’s Manual, Rev. 3.0
Bus Addresses Specified
SYNTAX REMOTE addr[,addr...]
addr is a device address (primary with optional secondary) or an external device
name.
RESPONSE None
MODE SC
•CA
BUS STATES REN, ATN
•UNL, MTA, LAG
SEE ALSO LOCAL, LOCAL LOCKOUT, Remote (Sub-Chapter 15B)
EXAMPLES PRINT#1,"REMOTE16,28" Assert REN and address devices 16 and 28 to
listen.
The REMOTE command asserts the Remote Enable ( REN ) bus management line. If the optional bus
addresses are specified, REMOTE also address those devices to listen, placing them in the Remote state.
REMOVE DEVICE
SYNTAX REMOVE DEVICE [[,]name...]
name is the external device to remove.
RESPONSE None
MODE Any
BUS STATES None
SEE ALSO MAKE DEVICE, KEEP DEVICE, REMOVE DOS NAME
EXAMPLES PRINT#1, “REMOVE DEVICE DMM”
The REMOVE DEVICE command removes the specific temporary or permanent Driver488 device that
was created with either the MAKE DEVICE command or the INSTALL program. This command also
removes a device that was made permanent through a KEEP DEVICE command. Notice that REMOVE
DEVICE cannot be used to remove devices having DOS names. The REMOVE DOS NAME command
must first be used to remove any associated DOS names from such devices before the devices are
removed via the
REMOVE DEVICE command.
REMOVE DOS NAME
SYNTAX REMOVE DOS NAME dosname
dosname is the name of the Driver488 DOS device to remove.
RESPONSE None
MODE Any
BUS STATES None
SEE ALSO MAKE DOS NAME, KEEP DOS NAME, REMOVE DEVICE
EXAMPLES PRINT#1, “REMOVE DOS NAME METER”
The REMOVE DOS NAME command removes the temporary or permanent Driver488 DOS device that
was created by either the MAKE DOS NAME command or the INSTALL program.
REQUEST
SYNTAX REQUEST[;] status
status is the service REQUEST status in the range 0 to 255 .
RESPONSE None
MODE *CA
BUS STATES SRQ if rsv is set
*SRQ if rsv is not set
SEE ALSO STATUS, CONTROL LINE, PPOLL CONFIG