Measurement Computing DASYLab - Manual (Page 65)

DASYLab – Standard Driver 989593 Configuring DASYLab for Daq Devices B-11
DBK Card Configuration
Note: DaqBoard/1000 Series devices do not support DBK options.
For DASYLab to properly operate DBK modules, they must be configured through the Hardware
Configuration dialog box. Also each DBK card connected must have its jumpers/switches properly set to
match the configuration.
Reference Note:
Consult the hardware manual (p/n 457-0901) in regard to connecting, configuring, and
powering each DBK card or module.
1. Click on Experiment and Hardware Setup or the Circuit board tool in the toolbar to open
the Hardware Configuration dialog box.
2. To add Analog DBK cards, double click on the Analog Inputs card branching off the main unit.
The card will expand into 16 connectors for the analog inputs.
Hardware Configuration Dialog Box
3. Click on the first available connector (0:) and then click on Properties.
A dialog box appears with a list of installed expansion channels (if applicable).
Expansion Selection Dialog Box