Measurement Computing DASYLab - Manual (Page 28)

3-10 Configuring DASYLab for PointScan 876994 DASYLab – Standard Driver
Setting Block Size and Scan Rate in Experiment Setup
8. In the Experiment Setup window, in the Global Settings frame (see above figure), verify that
Auto Select is unchecked and that the Block Size is set to 1.
9. In the Global Settings frame, under Sampling Rate/Ch, set the time value to the match the
value that was specified in the DataSocket Import Options box [step 3(h), page 3-9]. Set the
units to Sec. The resulting scan rate, i.e., data return per unit time, is for data to be returned
once every 0.1000 seconds. This is equal to 10 samples/sec.
For each DASYLab worksheet module ⎯ in the Experiment Setup window, set the Block
Size and the Sampling Rate to match that of the first module. This will ensure that the
data from each worksheet module coincides with the data from the DataSocket Import
module.
10. Close the Experiment Setup window.
11. From the Module pull-down menu, select Display, then select an appropriate display module.
This will allow you to see the data after the play button is clicked.
This completes the procedure for configuring DASYLab for PointScan.
DataSocket Import Module attached to a Digital Meter Module