Measurement Computing DASYLab - Manual (Page 38)

A-2 Configuring DASYLab for WaveBooks 989693 DASYLab - Standard Driver
Software Support Structure
Install DASYLab
1. Launch DASYLab installation from the DASYLab CD. Note that the CD should auto-start.
If the CD does not auto-start, run start.exe from the CD.
2. Select “Install DASYLAb.”
3. When prompted for your name, company and serial number, enter the requested data. Obtain the
serial number from the CD jacket. Keep the number in a safe place for future installations and
upgrades.
4. When prompted for the installation directory and program folder, use the default selection, or choose
another. We recommend that the default directory and location be used.
5. When prompted for Setup Type, choose from the available options.
We recommend that you select Typical.
6. Install the DEMO driver, and/or any of the other listed drivers as applicable.
After DASYLab has been installed you will install the IOtech Drivers from your IOtech Data
Acquisition CD, as described in the upcoming section.
Make sure a check mark appears next to your selection(s). Choices that are merely
highlighted and not checked will not be installed.
7. A final screen displays the selected options about to be installed. Be sure the report matches your
intended choices. Step back to modify settings if needed.
Note: After software installation is complete you may be required to restart Windows. After restart,
continue with the following section, Install Low-Level Hardware Driver.