Measurement Computing DASYLab - Manual (Page 31)

DASYLab – Enhanced Driver
977491 IOtech 640 & 650 Series Devices 4-3
6. Install the DEMO driver, and/or any of the other listed drivers as applicable.
After DASYLab has been installed you will install the IOtech Drivers from your IOtech Data
Acquisition CD, as described in the upcoming section.
7. Upon completing the DASYLab installation, exit from and remove the DASYLab CD.
Note: After software installation is complete you may be required to restart Windows.
After restart, continue with the following section, Installing DASYLab Drivers
for IOtech Devices.
Installing DASYLab Drivers for 640 and 650 Series Devices
Note: The installation will automatically perform version verification to ensure that only newer
support is installed.
1. Place the IOtech DSA CD (rev 2.1 or higher) into the host computer’s CD drive. The CD should
auto-start; if not, run the CD start.exe from the Windows Desktop.
2. After the intro screen appears, click <Enter Setup>.
3. After accepting the licensing agreement, select the hardware models that you will be using.
4. Select DASYLab Support.
5. Click the Start Install button. Follow the installation wizard configuration screens. Continue to
click [accepting the default values] until the DASYLab Hardware Driver Selection dialog
appears (following figure).