Measurement Computing DASYLab - Manual (Page 41)

DasyLab - Standard Driver 989693 Configuring DASYLab for WaveBook A-5
Configure the Hardware
Before configuring DASYLab's hardware settings, make sure the hardware is setup properly. Checking for
valid readings with WaveView first is recommended. If the hardware has jumpers, make sure they are in
the desired positions.
Use the following steps to setup DASYLab to work properly with your hardware.
1. Launch the DASYLab application.
2. Open the Hardware Configuration dialog box in either of two ways:
(a) click on the circuit board in the horizontal toolbar, or
(b) click on Experiment in the menu bar and then click on Hardware Setup.
A Hardware Configuration dialog box will appear, similar to that shown in the following figure.
Hardware Configuration Dialog Box
3. To change the acquisition device:
(a) Select the present acquisition device [from the configuration tree].
(b) Click on the <Properties> button.
The Card Setup dialog box will appear (following figure).