Measurement Computing DASYLab - Manual (Page 39)

DasyLab - Standard Driver 989693 Configuring DASYLab for WaveBook A-3
Install Low-Level Hardware Driver
If the hardware drivers for your device are not yet installed, or if you have received a new IOtech Data
Acquisition CD, follow these steps.
Both the low-level drivers, installed from the Data Acquisition CD, and the DASYLab
drivers, installed from the DASYLab CD, are required for DASYLab operation.
Note: The installation automatically performs version verification. Only newer support is installed.
1. Launch the Data Acquisition Software CD. Note that the CD should auto-start. If not, run start.exe
from the CD.
2. Select the hardware models that you will be using.
3. Select DASYLab Support.
4. Click the Start Install button.
5. When the DASYLab Hardware Driver Selection dialog appears select
Standard Driver [DaqBook/Board 100 & 2000 Series, DaqTemp, TempBook].
Use WaveView to verify connections and configurations. This use of WaveView can be very
beneficial, especially in applications making use of DBK signal conditioning cards and
expansion modules.
6. Verify your hardware installation using the Resource Test in
the Daq Configuration Control Panel Applet. Refer to the data
acquisition user’s manual for instructions on using the applet
and configuring device names.
Note: You can download the latest hardware and DASYLab drives
from our web site at www.iotech.com.
Selecting the Daq*
Configuration Control Panel Applet
Reference Note:
After completing the following driver-selection and hardware setup steps you will be ready to add
icons to your worksheet. Refer to DASYLab’s On-line Help for detailed information.