Measurement Computing DASYLab - Manual (Page 37)

DasyLab - Standard Driver 989693 Configuring DASYLab for WaveBook A-1
Appendix A Configuring DASYLab for WaveBook
Standard DASYLab Driver (DaqBoard/DaqBook/WaveBook/TempBook)
IOtech WaveBook users now have two choices of DASYLab drivers. These are:
Standard DASYLab Driver (DaqBoard/DaqBook/WaveBook/TempBook)
Enhanced DASYLab Driver (with multiple WaveBook and WBK40/41 support)
You should use the Enhanced DASYLab Driver if:
• You wish to run multiple WaveBook systems concurrently.
• You are using WBK40/41 modules in your system.
You should use the Standard DASYLab Driver if:
• You have already created DASYLab Worksheets for your system and you do not plan to use WBK40/41
modules or multiple WaveBooks in your system.
• You require optimal throughput performance while using a single WaveBook system.
If neither of the above scenarios applies, then either driver can be used for your WaveBook DASYLab application.
Note: You can download the latest hardware and DASYLab drives from our web site at www.iotech.com.
Reference Notes:
Users of the Enhanced DASYLab Driver refer to chapter 1.
Users of the Standard DASYLab Driver refer to this Appendix.
Install DASYLab …… A-2
Install Low-Level Hardware Driver …… A-3
Select the Driver …… A-4
Configure the Hardware …… A-5
Putting Modules on the Worksheet …… A-8
Working with the WaveBooks
and WBK Options …… A-8
WaveBook …… A-9
WBK14 …… A-8
WBK15 …… A-9
WBK16 …… A-11
WBK17 …… A-12
WBK18 …… A-13
WBK40 …… (refer to chapter 2)
WBK41 …… (refer to chapter 2)
FIFO Settings (for WBK30 Option) …… A-15
General Experiment Setup …… A-17