Measurement Computing DASYLab - Manual (Page 40)

A-4 Configuring DASYLab for WaveBooks 989693 DASYLab - Standard Driver
Select the Driver
1. Start DASYLab and go to Experiment / Select Driver (see following figure).
Experiment / Select Driver Window
2. When the driver selection menu is presented, select the desired IOtech hardware products from the
list. You may be prompted to restart DASYLab for the changes to take effect. If so, exit and restart
DASYLab before continuing.
3. Click Help / About DASYLab. The Information about DASYLab screen will appear (see following
figure).
4. In the DLL Driver frame, make sure you have version IOT5.06 or higher.
5. In the Virtual Driver frame, make sure you have DaqX 2.09 or higher.
“Information about DASYLab” Screen, “Version Tab” Selected.
Viewing Version Frames for: DASYLab, DLL Driver, and Virtual Driver.
6. Use the Additional Options tab to confirm that the options you purchased have been properly
installed.
If you did not receive the version listed on your purchase order, contact IOtech’s Technical
Support Department ([email protected]).
7. Click OK to close the Additional Options window.